lookitw.blogg.se - Cgminer pool

CGMINER POOL HOW TO
CGMINER POOL PASSWORD
CGMINER POOL DOWNLOAD

Increase your gpu-engine by around 50 and save the file.Go back to your nf file and open it again in notepad.Close cgminer if you have it open to edit the config file again.Start Overclocking your GPU in cgminer to squeeze out MHash: Re-open cgminer via cgminer.exe and after around 5 minutes record your MHash.Leave everything else the way it is and save the config file.

Change the gpu-memclock to about 1/3 of the default clock.

Change the gpu-engine to your default GPU core clock.

Navigate to and open your nf file in notepad.

Lookup your Graphics cards default core and memory clock speeds first thing.

Most newer cards can run around 80-85 degrees celsius safely for prolonged periods of time but I would not recommend letting it get hotter than this. Keep an eye on your GPU’s temperature when doing this as you want to make sure it doesn’t get too hot and damage the GPU. NOTE: if you are happy with the MHash you are getting at this point all you need to do is run cgminer.exe to begin mining the pool you setup earlier since its all saved in the config file you just created.īitcoin mining uses your GPU core and not the memory so you will want to clock your memories core down and over clock your GPU core.

It will ask about naming the config, just press enter for the default name (nf).

You will have a list of options show up, next press “W” for Write Config File.

After cgminer begins mining press “S” for settings.

If all information was entered correctly it should now start mining.Ĭreate a Config File for cgminer: (skip this if you already have a cgminer config file).

CGMINER POOL PASSWORD

Next enter your workers password when it asks and press enter.Next it will ask for your Worker so enter that (i.e.When it asks for your pool address enter it there with port (i.e.Navigate to the cgminer folder and open cgminer.exe.Unzip cgminer to your hard drive (somewhere you will remember).

CGMINER POOL DOWNLOAD

Download the newest version of cgminer from its Git Repository ( download link).

Setting up cgminer for the first time: (skip this if you already have cgminer running) I will explain the entire process of creating the config file to changing settings so that you get the most MHash out of your card possible. This being said its not that difficult to get it running and optimizing it for your graphics card. U3 is 50G then D = 50 * 2.Anyone who starts out mining Bitcoins for the first time generally stays away from cgminer because it takes a little bit of over clocking knowledge if you want to get the best Mhash/s from your GPU or GPU’s. Recommended difficulty is calculated as: D=H*2.3, H is the hashrate, G is unit.Į.g: S9 is 14T then D = 14000 2.3 = 32200, set to d=32200 In command line, it's: cgminer -o stratum+tcp://cn.ss.btc.com:1800 -u USER_NAME -p d=4096. No matter how low the hashrate is, the pool will never assign a difficulty less than 1024. md=1024 means that the miner's minimum difficulty is 1024. If your miners are extremely high or low, configuring a suitable difficulty will improve the efficiency.ĭifficulty parameters: d=4096 or d=4096,md=1024, Type these parameters into your password bar in the miner background system.ĭ=4096 means that the initial difficulty will be 4096 after its connection.

CGMINER POOL HOW TO

How to configure the difficulty of miners？